Silvercrest SDDD 7 A1 - Manual (Page 149)

SilverCrest SDDD 7 A1
English - 147
AUDIO SETUP PAGE
DOWNMIX
You can change the settings for using the analogue output here.
LT/RT: Choose this option if you are operating the DVD player (A) on a Dolby Pro
Logic decoder.
STEREO: Choose this setting if the sound is being played over two speakers. Stereo
sound will be output.
DIGITAL OUTPUT
SPDIF/OFF: Digital audio output (COAXIAL) is not enabled.
SPDIF/RAW: To output, e.g. to an amplifier with a Dolby digital decoder.
SPDIF/PCM: Standard setting for stereo signal output.
DOLBY DIGITAL
 DUAL MONO
STEREO:
A stereo signal is output via the speakers.
L-MONO: The left mono sound is output over both speakers.
R-MONO: The right mono sound is output over both speakers.
MIX-MONO: Left and right mono sound is output over both speakers as a mono signal.
 DYNAMIC
The Dolby digital sound format supports a dynamic setting which enables the difference in volume
between quiet and loud parts to be configured individually. Configuration is possible at 9 levels
from "OFF" to "FULL".