Silvercrest SDKT 1.76 A1 - Manual (Page 159)

SilverCrest SDKT 1.76 A1
English - 157
Troubleshooting
Handset does not work / blank
display
 Batteries inserted incorrectly - insert the rechargeable
batteries with the correct polarity.
 Batteries are flat - recharge the batteries.
 Handset powered off - press and hold the End call button
[5] to power the handset on.
The antenna icon is flashing
 Handset out of range – take the handset closer to the
base.
 Base has no power – check the base power supply.
 The range is reduced because you have enabled ECO
Mode. Switch from ECO Mode to "normal”.
No ringtone from handset
 Re-activate the ringtone or increase the ringer volume.
No ring or dial tone for outgoing
calls
 Telephone cable not connected properly - make sure that
you have connected the telephone cable properly.
The answer machine does not
record any message.
 Check the answer machine operating mode.
 The memory is full. Delete old messages.
Impossible to dial out
 Keypad locked – disable the key lock function.
When using the pulse dial mode with a PBX, it is possible for malfunctions to occur. This
is because the PBX misinterprets the dial pulses. Switch to tone dial mode.
Environment and Recycling
Devices marked with this symbol are subject to European Directive 2002/96/EC. All
electric and electronic devices must be disposed of separately from household waste
at official disposal centres. Avoid hazards to the environment and dangers to your
personal health by disposing of the device properly. For further information about
proper disposal, contact your local council, waste disposal office or the shop where
you bought the device.
Recycle the packaging material properly too. Cardboard packaging can be taken to
paper recycling containers or public collection points for recycling. Any film or plastic contained in the
packaging should be taken to your public collection points for disposal.