Resetting the lamp timer, Maintaining the projector, Then press – Epson 7900p User Manual
Page 107: You see this screen: 4. select, You see this prompt: 5. select, When you’re finished, press
Maintaining the Projector
107
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu.
1. Plug the projector in and turn it on.
2. Press the
Menu
button on the remote control (or on the
projector’s control panel). You see the main menu.
3. Use the
pointer button on the remote control (or the arrow
buttons on the projector) to highlight
About
, then press
Enter
.
You see this screen:
4. Select
Reset Lamp Timer
, then press
Enter
. You see this
prompt:
5. Select
Yes
, then press
Enter
.
6. When you’re finished, press
E
SC
or
Menu
to exit.
note
The lamp usage timer shows
0H until you’ve used the
lamp for at least 10 hours.
Video
Audio
Setting
User's Logo
Advanced1
About
Reset All
Frequency
Source
V ---.---Hz
Reset Lamp Timer
H ---.---kHz
Lamp (High Brightness)
0H
SYNC Mode
SYNC Polarity
------
V ------
H ------
Resolution
Refresh Rate
---.-- Hz
----x ----
Computer
Input Signal
:
:
:
(Low Brightness)
0H
:
:
:
:
:
:
: Auto
Execute
[ ]: Select [ ]: Enter
[Menu]: Exit
Effect
Advanced2
:
Lamp usage
Reset Lamp Timer
Execute?
YES
NO
Reset Lamp Timer
Execute?
YES
NO