Edimax Technology Broadband Router - Manual (Page 39)

38
Add PC You can click Add PC to add an access control rule for users by IP addresses.
Remove PC
If you want to remove some PC from the "IP Filtering Table", select the PC you want to
remove in the table and then click "Delete Selected". If you want remove all PCs from the
table, just click "Delete All" button.
Filter client PC by MAC Check “Enable MAC Filtering” to enable
address MAC Filtering.
Add PC
Fill in “Client PC MAC Address” and “Comment” of the PC that is allowed to access the
Internet, and then click “Add”. If you find any typo before adding it and want to retype
again, just click "Reset" and the fields will be cleared.
Remove PC
If you want to remove some PC from the "MAC Filtering Table", select the PC you want to
remove in the table and then click "Delete Selected". If you want remove all PCs from the
table, just click "Delete All" button. If you want to clear the selection and re-select again,
just click
“Reset”.
You can now configure other advance sections or start using the router (with the advance settings in place)
Parameters Description
Client PC Description The description for this client PC rule.
Client PC IP Addresses
Enter the IP address range that you wish to apply this Access Control rule. This is the
user
’s IP address (es) that you wish to setup an Access Control rule.
Note: You need to give your LAN PC clients a fixed/static IP address for the Access
Control rule to work properly.
Client PC Service
You can block the clients from accessing some Internet services by checking the services
you want to block.
Protocol This allows you to select UDP, TCP or both protocol types you want to block.
Port Range
It can be assign up to five port ranges. The router will block clients from accessing
Internet services that use these ports.
Apply Changes Click “Apply Changes” to save the setting.
Reset Click “Reset” to clear all fields.
Click <Apply Changes> at the bottom of the screen to save the above configurations. You can now configure other
advance sections or start using the router (with the advance settings in place)