EVGA 730I - Manual (Page 70)

EVGA
60
¾ Expert
Use the
Page Up and Page Down keys to select
Expert
. When Expert is
selected, all timing categories are enabled for manual input. Note that you
should set the value to Optimal to use the manufacturers’ recommended
values.
¾
tCL
: CAS# latency (options are Auto and 1 through 7).
¾
tRCD
: RAS#-to-CAS# Delay for Read/Write commands to the
same bank (options are Auto and 1 through 7).
¾
tRP
: Row Precharge time. This is the Precharge-to-Active or Auto-
to-Refresh of the same bank (options are Auto and 1 through 7).
¾
tRAS
: This is the minimum RAS# active time (options are Auto and
1 through 31).
¾
Command Per Clock
: This is the command timing setting on a per
clock unit basis (options are Auto, 1 Clock and 2 Clock).
¾
tRRD
: RAS#-to-RAS# delay of different banks (options are Auto
and 1 through 15).
¾
tRC
: RAS#-to-RAS# or auto refresh time of the same bank (options
are Auto and 1 through 31).
¾
tWR
: The Write recovery time (options are Auto and 2 through 6).
¾
tWTR
: This is the minimum write-to-read delay with the same chip
selected (options are Auto and 1 through 15).
¾
tREF
: This is the DRAM refresh rate (options are
Auto
,
7.8uS
, and
3.9uS
)..
Parameters Settings Current Value
Memory Timing Setting [ Expert ]
tCL (CAS Latency) [Auto(7)] 7
tRCD [Auto(7)] 7
tRP [Auto(7)] 7
tRAS [Auto(20)] 20
Command Per Clock (CMD) [Auto(1T)] 1T
** Advanced Memory Settings **
tRRD [Auto(4)] 4
tRC [Auto(27)] 27
tWR [Auto(10)] 10
tWTR [Auto(14)] 14
tREF [Auto] 7.8uS