EVGA 730I - Manual (Page 22)

Hardware Installation
EVGA
11
Use the following procedure to install memory DIMMs. Note that there is only
one gap near the center of the DIMM slot. This slot matches the slot on the
memory DIMM to ensure the component is installed properly.
1.
Unlock a DIMM slot by pressing the module clips outward.
2.
Align the memory module to the DIMM slot and insert the module
vertically while applying light downward pressure to properly seat the
DIMM. The plastic clips at both sides of the DIMM slot automatically lock
the DIMM into the connector.
Installing the Motherboard
The sequence of installing the motherboard into the chassis depends on the
chassis you are using and if you are replacing an existing motherboard or
working with an empty chassis. Determine if it would be easier to make all the
connections prior to this step or to secure the motherboard and then make all
the connections. It is normally easier to secure the motherboard first.
Use the following procedure to install the I/O shield and secure the
motherboard into the chassis.
Note:
Be sure that the CPU fan assembly has enough clearance for the chassis
covers to lock into place and for the expansion cards. Also make sure the
CPU Fan assembly is aligned with the vents on the covers.
DIMM Slot 1
DIMM Slot 2
DIMM Slot 4
DIMM Slot 3