EVGA 730I - Manual (Page 28)

Hardware Installation
EVGA
17
Connecting Internal Headers
Front Panel Header
The front panel header on this motherboard is one connector used to connect
the following four cables.
(see Table 2 for pin definitions):
‰ PWRLED
Attach the front panel power LED
cable to these two pins of the connector.
The Power LED indicates the system’s
status. When the system is turn on status,
the LED is on. When the system is turn off
status, the LED is off. When the system is
in S1, S1, S3, S4 status, the LED is blink.
Some chassis do not have all four cables. Be sure to match the name on the
connectors to the corresponding pins.
‰ PWRSW
Attach the power button cable from
the case to these two pins. Pressing
the power button on the front panel
turns the system on and off rather
than using the power supply button.
‰ HD_LED
Attach the hard disk drive indicator
LED cable to these two pins. The
HDD indicator LED indicates the
activity status of the hard disks.
‰ RESET
Attach the Reset switch cable from
the front panel of the case to these
two pins. The system restarts when
the
RESET switch is pressed.
Table 2.Front Panel Header Pins
Pin Signal
HD_LED
1 HD_PWR
3 HD
Active
PWRLED
2 PWR LED
4 STBY LED
RESET
5 Ground
7 RST
BTN
PWRSW
6 PWR BTN
8 Ground
No Connect 9 +5V
Empty 10 Empty
Card-edge
side