beautypg.com

Fig.4 fig.3 fig.2 fig.1 – Sealey AK435 User Manual

Page 2

background image

fig.4

fig.3

fig.2

fig.1

2. INTRODUCTION & OPERATION

2.1. INTRODUCTION

Weatherproof composite spotlight with swivel handle feature allowing pistol grip or carry handle operation. Integral foot doubles as carry handle

when used in pistol grip mode. Ø110mm Lens with halogen bulb produces 1-million candle power of intense white light, suitable for a variety of

industrial, domestic and leisure applications. Supplied with sealed 6Volt 4Ah battery, in-vehicle charger and 230 - 6Volt battery charger pack.

Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 000 000 candle power

Cell Type ................................................... 6V - 4.0Ah Rechargeable

Lens Diameter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110mm

Operating time ...................................................................... 40mins

2.2. OPERATION

WARNING! Ensure you read and understand safety instructions before use.

Reminder: These spotlights are designed for intermittent use only. Continuous use may damage the unit.

1. Charge the battery before use.

IMPORTANT: Turn off spotlight while charging. Failure to do so will damage the charger plug/vehicle

plug.

2. Turn spotlight ‘On’ and ‘Off’ by the switch on the main body. See fig.2-1.

3. To use as shown in fig.1, press locking button (fig.1-1) and rotate the handle (fig.1-2) anti-clockwise, to grip position. fig.2 shows the

arrangement for standing the spotlight on a surface, using the adjustable support.

2.3. BATTERY CHARGING

WARNING! Ensure you read, understand and apply safety instructions relating to the battery and charger before use.

2.3.1. Charger plug

1. Plug the charger adaptor (fig.3) into the jack inlet on the spotlight body (fig.1-3) and stand the spotlight in a safe location ready to charge.

2. Ensure the spotlight is turned ‘Off’ and then plug charger into the mains supply.

3. Allow approximately 15 hours for the initial charge and 10 hours for subsequent charges. When fully charged, switch off the mains supply

and unplug the charger. Remove the charger adaptor (fig.3) from the spotlight and seal the jack inlet. The spotlight may now be used.

4. Store the charger in a safe, dry location.

Notes: a) A fully charged battery will last for approximately 40 minutes

b) Do not let the battery fully discharge.

2.3.2. Vehicle plug

1. Ensure spotlight is turned ‘Off’ and then plug the 12 volt vehicle plug adaptor (fig.4.) into the jack inlet on the spotlight body (fig.1-3). Stand

the spotlight in a safe location ready to charge.

2. Insert plug into vehicle cigarette lighter socket. Allow approximately 15 hours for the initial charge and 10 hours for subsequent charges.

3. When fully charged, unplug the adaptor from the vehicle socket and from the spotlight

before turning the spotlight on.

4. Store the adaptor in a safe, dry location.

NOTE: Charging the spotlight from an 12 volt vehicle socket will drain the vehicle battery, unless the engine is running.

Original Language Version

AK435.V3 Issue: 1 - 07/03/11