Sealey WL18W User Manual
Led work floodlight 18w/24w, Wl18w, wl24w, Instructions for
1.1.
ELECTRICAL SAFETY
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following: You must check all
electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets and any other connectors
for wear or damage.
1.1.1. Ensure that cables are always protected against short circuit and overload.
1.1.2. Regularly inspect power supply cables check all connections to ensure that none are loose.
1.1.3.
Important: Ensure that the voltage marked on the appliance matches the power supply to be used and that the circuit is fitted with the
correct fuse. If in doubt, consult a qualified technician to connect the floodlight to a fused and switched DC supply.
1.1.4.
DO NOT pull or carry the floodlight by the power cable.
1.1.5.
DO NOT use worn or damaged cables, plugs or connectors. Immediately have any faulty item repaired or replaced by a qualified
technician.
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
InstRuCtIons FoR:
LED WORK FLOODLIGHT 18W/24W
moDEl no:
WL18W, WL24W
1. SAFETY
3. SPECIFICATION
2. INTRODUCTION
Wl18W, Wl24W Issue: 1 - 08/07/14
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park
,
Bury st. Edmunds, suffolk,
IP32 7AR
www.sealey.co.uk
Original Language Version
© Jack sealey limited
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
Model No: . . . . . . . . . . . . . . . . . . .WL18W
Power:. . . . . . . . . . . . . . . . . . . . . . . . . 18W
lumen output:.. . . . . . . . . . . . . . . . 1080lm
supply:.. . . . . . . . . . . . . . . . . . . . 9-32V DC
Dimension: . . . . . . . . . . . . . . . . . . Ø116mm
Model No: WL18W
Floodlight with 6 x 3W Epistar™ high power lEDs producing up to 1080 lumens output. IP67 Rated with a powder coated die cast aluminium
housing. suitable replacement for traditional halogen work lights with up to 65% less power consumption. supplied with grade 304 stainless
steel mounting bracket and fixings.
Model No: WL24W
Floodlight with 8 x 3W Epistar™ high power lEDs producing up to 1440 lumens output. IP67 Rated with a powder coated die cast aluminium
housing. suitable replacement for traditional halogen work lights with up to 57% less power consumption. supplied with grade 304 stainless
steel mounting bracket and fixings.
Model No: . . . . . . . . . . . . . . . . . . .WL24W
Power:. . . . . . . . . . . . . . . . . . . . . . . . . 24W
lumen output:.. . . . . . . . . . . . . . . . 1440lm
supply:.. . . . . . . . . . . . . . . . . . . . 9-32V DC
Dimensions: . . . . . . . . . . . . . 142 x 122mm
Wl18W
Wl24W
m10
m8