Ultimate Speed AZ-600 - Manual (Page 9)

9 GB
We are not liable for any damage and
consequences resulting from improper use,
non-observance of safety precautions,
assembly mistakes or any modifications to the
product.
Only use original parts included in the
delivery scope. Contact the address
below if you have any requests regarding
replacement parts.
Select the final location for your tyre holder
before attaching any tyre. Moving the
product later on should be avoided due to its
heavy weight and risk of overturning!
Install the tyre holder on a flat and stable
surface only. The installation surface must not
be tilted, as a stable stand can otherwise not
be guaranteed.
Check the tyre holder regularly for damage
and wear and stop using it in case of any
defects.
Do not use the tyre holder for any other
purposes (e.g. as ladder or safety stand).
Due to its risk of overturning the tyre holder
(– Assembly) must only be loaded from
down to up in order to avoid injuries.
Keep children away from the tyre holder.
Do not load the tyre holder beyond the
maximum permissible load (– Technical
Data).
§
INSTALLATION
First attach the plastic centrepiece 1 to
the crossbeam 2 of the stand (fig. A) (if
necessary use a rubber mallet to facilitate
attachment) and secure it with the screws
2 and screwdriver provided (see storage
pouch) (fig. A).
Attach 1 pin with rings and chain 5 each to
each of the discs 4 (fig. B).
Insert the center length of pipe 7 (fig. C) into
the opening of the plastic centrepiece 1 ;
slide the disc 4 over the center length of
pipe. Insert the pin 5 through the lowest
borehole and attach the disc 4 (fig. D).
Attach the rim with wheel. Slide the disc 4
over the center length of pipe 7 ; insert the
pin 5 through the next available bore hole
and then attach the disc 4 (fig. E).
Attach the rim with wheel (fig. E).
Then attach the end length of pipe 8 until
the ball of the end length of pipe 8 locks
into the opening of the center length of pipe
7 (fig. F). Continue as described previously
until all 4 wheels are attached properly
(fig. G).
Cover the entire tyre holder with the
protective cover.
§
TIPS FOR USING THE WHEEL
MARKERS
Read the wheel markers’ indication to find out
for which wheel each of them is intended. Attach
the respective wheel marker to the valve of the
corresponding wheel.
§
TIPS FOR USING THE TIRE
TREAD DEPTH GAUGE
Before using the tire tread depth gauge, inquire
the legal regulations regarding tire tread depths.
59005_DE_GB_02.indb 9 9/4/14 10:21 am