Ultimate Speed AZ-600 - Manual (Page 8)

8 GB
TYRE HOLDER
Congratulations!
With your purchase you have chosen a product
of very high quality.
§
INTRODUCTION
Get familiar with this product before
assembling. Read the following
assembly instructions and safety
precautions carefully. Use the product only
as described and only for the intended use
as mentioned. Keep this manual for future
reference. When passing on this product to third
parties make sure to also hand over all relevant
documentation.
§
INTENDED USE
The tyre holder is intended for storing tyre with /
without wheels. Any use other than mentioned
before or modifications to the product are not
permitted and can cause injuries and / or
damage to the product. The manufacturer is not
liable for any damage resulting from unintended
use. The product is not intended for commercial
use.
§
PART DESCRIPTION
1 Plastic centrepiece (1x)
2 Crossbeam (4x)
3 Screw (4x)
4 Disc (4x)
5 Pin with rings and chain (4x)
6 Washer (4x)
7 Center length of pipe (without stopper) (1x)
8 End length of pipe (with stopper) (1x)
§
TECHNICAL DATA
For 18 inch / approx. 46 cm wheel rims and tire
section width of max. 225 mm (225/55 R 18).
Maximum load per each disc: 25 kg
Maximum total load:
100 kg
§
ACCESSORIES
Remove all packaging materials.
Make sure there is no packaging residue left
within the tyre holder. Check the delivery content
for completeness and any potential transport
damage. In case the product is incomplete or
damaged, contact your dealer.
4 wheel markers for attachment to the valves
Tire tread depth gauge
Air pressure tester
Protective cover
Screwdriver
Storage pouch
Hardware bag
SAFETY INFORMATION
Carefully read these assembly
instructions before using the
product. The instructions contain
important information related to your safety
and to the use and maintenance of the
product.
Persons or children who are not capable of
using this product safely due to their limited
physical, sensory or mental capabilities, or
lack of knowledge or experience, must not
use this product unless they have been given
supervision or instructions on the safe use of
the product by a person responsible for their
safety.
Observe all safety precautions in order to
avoid damage from improper use! Observe
all warnings on the product.
Keep the assembly instructions for future
reference. When passing on this product to
third parties make sure to also hand on these
assembly instructions.
59005_DE_GB_02.indb 8 9/4/14 10:21 am