Miomare Z31166B - Manual (Page 5)

5 GB
Eco-function / saving water
The tap has a water-saving function. This feature
limits the rate of water flow through the tap. The
flow can be infinitely regulated between 0–100 %
by means of a stop.
Turn off the main water supply.
Remove the red / blue hot / cold label 8
carefully by a small flat screwdriver (see Fig. C).
Release the lock screw 7 by turning it anti-
clockwise using a hexagon socket screw key.
CAUTION! Do not take the screw completely
out; just loosen it until the control lever can be
easily taken off.
Take off the control lever.
Loosen the cartridge end ring
9 by hand,
then screw off the cartridge locking ring 10 by
using a pipe wrench.
Note: The setting screw 12 for regulating the
water flow is in the lever arm, which projects
from the cartridge (see Fig. D).
To reduce the flow, turn the setting screw anti-
clockwise. This limits the movement of the lever
arm and therefore the movement of the control
lever as well. The flow is reduced as the control
lever now cannot be lifted quite so high.
Note: The more you turn the screw anticlock-
wise, the more the flow is reduced.
Tighten the cartridge locking ring 10 onto the
lever arm again by using a pipe wrench, then
tighten the cartridge end ring
9 by hand.
Place the control lever back on to the lever arm
and tighten the locking screw by turning it
clockwise using a hexagon socket screw key.
Press the red / blue hot / cold label 8 into the
opening.
Turn on the main water supply and check the
water-saving function.
Setting the temperature limiter
The cartridge 11 in this unit has a temperature limiter.
This function is not activated in the factory (neutral
setting).
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Turn off the main water supply.
Remove the control lever
6 as described in
the section on “ Eco-function / saving water“.
Now pull the setting ring 13 upwards with the
help of a screwdriver.
Note: Do not remove the cartridge.
Place the setting ring in the desired position as
shown in Fig. E.
Place the control lever back on to the tap. To
do this, follow the procedure described in the
section on “ Eco-function / saving water“.
Turn on the main water supply and check the
temperature limiter.
Maintenance and cleaning
Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle 5 at regular intervals
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.