Miomare LED Washbasin Fitting / LED Bath/Shower Fitting - Manual (Page 8)

8 GB/IE
Installation / Operation / Maintenance and Cleaning
Connect a standard shower hose to the shower
connector 8 .
Connect a standard shower head to the
shower hose.
Note: Also refer to the assembly instructions for
the accessories.
Operation
Start-up
After the initial commissioning, carefully check all
connections for leaks.
Check the operation of the fitting. To do so,
swing the handle 16 into all permissible posi-
tions.
Note: the fitting features an LED light. The LED is lit
through an integrated turbine (without batteries). The
LED colour changes automatically based on the water
temperature through an integrated temperature
sensor:
· up to approx. 33°C blue,
· from approx. 33-43°C green,
· over approx. 43°C red.
Note: over approx. 53°C the LED light will begin
to flash red to warn of potential scalding.
Note: when starting the fitting for the first time the
LEDs will first flash blue, green and red before indi-
cating the temperature based on the temperature
(self-test).
Note: If the tap has not been used for a long pe-
riod, flush the pipes thoroughly to avoid stagnation
and build-up of residue.
Open the main water supply.
Lift the handle
16 and swing it to the right or
left in order to regulate the speed or tempera-
ture of the water.
Hot water:
Swing the handle
16 to the left.
Cold water:
Swing the handle
16 to the right.
Tub filler / shower diverter
Manually switch between the tub filler 10 to shower
function by lifting and lowering the diverter 7 .
Tub mixer:
Lower diverter
7 .
Shower function:
Lift diverter
7 .
Note: switching manually means: when turning
the water off with the shower function activated, the
shower function will remain on. When starting the
water again, the shower function will remain active
until it is switched to tub filler.
Maintenance and Cleaning
Maintaining and
cleaning the tap
Please note that sanitary taps require special care
and attention. Therefore, please follow the instructions:
When cleaning, never use petrol, solvents,
aggressive cleansers or hard cleaning brushes
etc. These could damage the surface of the
product.
Dry your fitting with a cloth after every use to
prevent any lime deposits.
Clean the product with a damp, soft cloth and
a mild cleaning agent if required.
Non-observance of the above care advice can be
expected to result in damage to the surfaces of the
product. This will inevitably invalidate the guarantee.
Replacing the LED insert
If the LED lamps fail to light, the LED insert may be
replaced.