Everpure 327 - Manual (Page 42)

Cold Drink Center (327/328) Operator’s Guide
August, 2003 Page 36 3280020
SET UP A DRINK
Be sure that the cup sizes you set in "Set Up Cup Sizes" on page 35, agree with
the cup sizes actually in your machine. All procedures for setting up the drinks are
similar, so this example will demonstrate how to set up the A selection, regular
size drink.
1. Press , then press until the display shows
SETUP -- *
. The
star (
*
) represents the selection (A, B, etc.). The dash (
-
) represents the
size of the selection.
2. Press A. (If you were setting up the A selection for the large size drink, you
would press 1 first, then A.) The display shows something similar to:
CLD. A 12.00 . This means that the currently set still water throw time for the
A selection is 12.00 seconds. Enter a new time if desired.
3. Press . The display shows CRB. A 12.00 . This means that the
currently set carbonated water throw time for the A selection is 12.00
seconds. Enter a new time if desired. A value of .00 will lock out carbonation
for the selection.
4. Pressing after each display will cause the following screens to
appear:
SRP. A View and change the settings for syrup
PCT. A View and change the settings for percentage of carbonation (0-100).
A value of 100 will lock out non-carbonation for the selection.
ICE. A View and change the settings for ice throw time
ICE. A+ View and change the settings for extra ice throw time
OPTIONS:
a. At any of the preceding displays, you can press to test throw that
item.
b. At any of the preceding displays, you can press
*
or # (on the selection
switch panel) to step through a list of that item's throw times for other
selections where that item is active. For example, pressing # at the
CLD. A display will show the throw time for either CLD. 1A or CLD. B (depend-
ing on how the drink sizes are set up). This is a handy way to move from
one selection to another without going to the
SETUP screen first.
NOTE
If you try to set up a selection that is not configured, the
SETUP
screen will remain in the display.