Everpure 327 - Manual (Page 41)

Cold Drink Center (327/328) Operator’s Guide
3280020 Page 35 August, 2003
SET UP CUP SIZES
Make sure the cup sizes you select agree with the cups you have actually loaded
during setup.
1. Press then until the display shows X OZ Y . "X" is the
currently selected drink size for the cups in turret 2 (normally large cups), "Y"
is the currently selected drink size for the cups in turrets 1A and 1B (normally
regular cups).
2. Press to cycle through the available #1 cup ring sizes; press
to cycle through the available #2 cup ring sizes.
3. Any changes made to the cup sizes must be "locked in". There are two
ways to do this:
a. If you are keeping some cup sizes the same, or putting the cups in differ-
ent cup rings, press and hold . The display momentarily shows
CLEARING
, two beeps sound, then shows
FINISHED
. This will reassign the
old throw times to the new cup ring, if possible.
b. If you are loading all different size cups, or want to load all new default
times, press and hold . The display momentarily shows
CLEARING , two beeps sound, then shows FINISHED . This will reload the fac-
tory default times for all cup sizes, clearing any custom throw times you
have established. (See"Factory Default Throw Times and Volumes"
on page 37.)
NOTE
Machines with diaphragm pumps (see "Configure Pump
Type" on page 39) can only vend one cup size.
4. CONTINUE.