Florabest FSG 85 B1 - Manual (Page 53)

53
GB
Keep hands away from the grind-
ing disk and chain teeth when the
equipment is in use. Do not move
the chain by hand. There is a risk of
injury.
Switching on and off
Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the
mains.
1. To switch on, press the on/off switch
(“I“ position); the equipment starts up
(see 1).
2. To switch off, press the on/off switch
(“0“ position); the equipment switches
off (see 1).
. The.disk.will.continue.to.
run.after.the.equipment.is.
switched.off..There.is.a.risk.
of.injury.
Protection.against.overheating.and.
restart:
The unit will not automatically restart fol-
lowing an automatic cutout due to over-
load.
To restart the grinder, press the On/Off
switch (“ I“ position). The unit will start
(see 1).
Test.run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 30 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
.Sharpening the saw chain
When working with the saw chain,
keep clean the ventilation openings
(see “Maintenance and cleaning”).
In case of a blockage, switch off
the equipment and disconnect from
the mains. Only then should the
blockage be removed.
. An.incorrectly.sharpened.
saw.chain.may.damage.the.
chain.the.increase.the.risk.of.
the.saw.jumping.back...
Ensure.that.the.chain.is.
aligned.accurately..
Observe.the.correct.rake.an-
gle.and.minimum.dimensions.
of.the.saw.chain..Remove.as.
little.material.as.possible...
Do.not.grind.in......
drive.(a).or.con-
necting.(b).links,.
otherwise.the.saw.
chain.may.rupture...
In.the.event.of.non-observ-
ance,.there.is.a.risk.of.acci-
dents.when.handling.the.
chainsaw.
.Instructions.for.sharpening
• Clean the saw chain before you sharp-
en it. Use a brush or cloth to remove
oily wood chips or residual oil.
• After sharpening, all cutting links must
be of equal length and width.
• The chain is worn and must be re-
placed with a new saw chain if only
approx. 4 mm of cutting tooth remain.