Florabest FRM 1200 B3 - Manual (Page 10)

10
GB
60.mm.- Tall cutting height
40.mm - Medium cutting height
20.mm - Short cutting height
F 1. Unscrew the wheels (5).
2. Screw the wheels (5) back on in
the desired position.
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 – 60
mm for a used lawn.
A higher cut height should be se- A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.
Switching On and Off
1. Insert the power cable plug into
the socket (
A
9) on the curved
handle ( A 1).
2. To relieve the strain, form a loop
with the end of the power cable
and hang this into the strain reli-
ef (11). See the diagram .
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (10) on the handle at the
same time as pressing the start
lever (12). Release the release
button (10).
6. To switch off, release the start
lever (12).
After switching off the equipment,
the blade continues to turn for sev-
eral seconds. Do not touch the mov-
ing blade. There is a risk of injury.
Working with the
Lawnmower
Regular mowing encourages increased foli-
ation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Start mowing near the socket and work
away from the socket.
• Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
• Run the equipment at a walking pace,
in tracks that are as even as possible.
For gap-free mowing, the tracks should
always overlap by a few centimetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
• Clean the equipment after each use, as
described in the chapter on “Cleaning,
Maintenance and Storage”.
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.
Cleaning,
Maintenance and
Storage
Have work that is not described
in these instructions carried out by
a customer service centre that we
have authorised. Use only original
parts.