Florabest FRM 1200 A2 - Manual (Page 13)

13
CY IE GB
Technical
Specifications
Electric Lawnmower ......... FRM 1200 A2
Motor input power ..........................1200 W
Mains voltage ...................... 230V~, 50 Hz
Idling speed ............................... 3700min -1
Blade width .................................. 330 mm
Cut height .........................20 / 40 / 60 mm
Protection class ................................... II
Protection type...................................IP 24
Weight ........................................... 8.35 kg
Lawn box volume................................. 32 l
Sound pressure specification (LpA)
85.6 dB(A); KpA = 1.91 dB(A)
Noise level specification
measured (LWA) ........................................
93.5 dB(A); KwA = 1.91 dB(A)
guaranteed ...............................96.0 dB(A)
Vibration on the handle
(an) .............................................2.03 m/s 2
Do not exceed the maximum permitted
network impedance of 0.313 Ohms at the
electrical connection point.
To be on the safe side, check with your lo-
cal electric utility to verify that the junction
point of the mains has enough continuous
current carrying capacity for the unit.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool
is turned off and times when the
tool is turned on but is running
idle).
The noise and vibration values have
been determined in accordance with the
standards and regulations specified in the
declaration of conformity.
Technical and visual modifications may
be made without notice in the course
of further development. All dimensions,
information and specifications in these
operating instructions are therefore not
guaranteed. As such, no assertion of legal
claims can be enforced on the basis of the
operating instructions.