Florabest FRM 1200 A2 - Manual (Page 10)

10
IE GB CY
Operation
Hanging On / Removing the
Grass Box
E
1. To hang on the grass box (4), lift
the collision guard (7) and hang
on the grass box. Fold the col-
lision guard (7) onto the grass
box (4). It holds the grass box in
the correct position.
2. To remove the grass box (4),
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).
Adjusting the Cut Height
Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
To adjust the lawn mower‘s cutting height
change the position of the wheel axles as
follows:
60 mm - große Schnitthöhe
40 mm - mittlere Schnitthöhe
20 mm - geringe Schnitthöhe
1. Reach under the body of the
lawn mower (6) and pull the
wheel axle towards you.
2. While pulled, the wheel axle can
be moved up or down to any of
the three cutting heights.
3. If the height is correct, just let
go of the spring-loaded wheel
axle to let it snap back into
working position.
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 – 60
mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Observe the noise protection and
local regulations.
Switching On and Off
F
1. Insert the power cable plug into
the socket (9) on the curved
handle (1).
2. To relieve the strain, form a loop
with the end of the power cable
and hang this into the strain reli-
ef (11). See the diagram G .
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (10) on the handle at the
same time as pressing the start
lever (12). Release the release
button (10).
6. To switch off, release the start
lever (12).
After switching off the equipment,
the blade continues to turn for
several seconds. Do not touch the
moving blade. There is a risk of
injury.
Working with the Lawnmower
Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.