Florabest FGS 10 A1 - Manual (Page 11)

11
GB IE
Loading procedure
Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Charge the battery only in dry
areas.
The external surface of the bat-
tery must be clean and dry be-
fore the charger is connected.
There is a risk of injury from
electric shock.
Charge only with the enclosed
original charger. Ensure that the
equipment is charged for no longer
than 8 hours without interruption.
The battery and equipment could
be damaged and they consume
energy unnecessarily in case of
longer charging time. Overcharg-
ing invalidates the guarantee.
• Charge the battery before initial
use (charging time 8 hours). Do not
charge the battery for several short
periods in succession.
• A new battery or one that has been
unused for a longer period must initial-
ly be charged and will achieved its full
capacity only after approx. 5 charge/
discharge cycles. If the battery is used
correctly, it can be recharged up to
1000 times.
• A long battery life can be achieved
by regular use of the battery. Re-
charge the battery or use another,
fully charged battery if the equipment
runs too slowly. Avoid completely dis-
charging the battery. Deep discharges
shorten the life of the battery.
• A significantly shortened operating
time despite charging indicates that
the battery is worn out and needs
to be replaced. Use only an original
replacement battery, which can be ob-
tained through the service centre.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
1. Connect the charger cable plug
(22) with the charger socket on
the tool (8).
2. Plug the charger (21) into the
wall mains power outlet.
3. The LED (4) will glow red as
long as the tool is connected to
the mains power supply. The re-
commended charging time is 5-8
hours.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug from the tool.
Assembling the
telescopic shaft
For packaging reasons, the tel-
escopic handle is delivered in two
sections. When connected together,
the two sections lock into each
other and cannot subsequently be
detached.