beautypg.com

Operation, Gb mt – Florabest FRT 450 A1 User Manual

Page 46

background image

46

GB MT

Dismantling the spacer:

5. To remove the spacer, loosen

the 3 cross-head screws on the

protective cover (8) and remove

the protective cover and spacer

(10).

6. Remount the protection cover

(8).

Mounting the additional handle:

1. Unscrew the screw (11) on the

additional handle included in de-

livery (12).

2. Pull the ends of the additional

handle (12) apart and push this

over the handle holder (16).

3. Screw on the additional handle

(12) using the screw (11).

Operation

WARNING: Danger of injury!

Never use the trimmer without its

protective cover. Always check

the operability of the trimmer

before it is used. Check that the

mains voltage is the same as

indicated on the rating plate. Al-

ways wear goggles when work-

ing with the trimmer.

Please observe local regulations

concerning noise protection.

Switching ON and OFF

1. Remove the protection card-

board packaging on the line cut-

ter (

13).

2. Form a loop in the end of the ex-

tension cable, conduct it through

the opening in the upper handle

(1) and hang it on to the strain

relief (4).

3. Connect the trimmer to the

mains socket.

4. Ensure a safe stance and hold

the equipment firmly with both

hands. Do not deposit the cutting

head on the ground.

5. To switch on depress the ON

/ OFF switch (2). Release the

switch to switch off.

After the trimmer has been

switched off the cutting head will

continue to rotate for a few sec-

onds. Keep hands and feet well

away. There is the danger of cut-

ting damage.

Risk of injury from cuts.

The ON / OFF switch must not

be locked in place. The trimmer

must not be used if the switch is

damaged. There is the immedi-

ate danger of injury if the motor

does not switch off after the ON /

OFF switch has been released.

Caution: Always remove grass

residue from the line cutter so that

the cutting effect is not impaired.

Trimmer settings

Adjusting the additional handle:

The additional handle can be set in dif-

ferent positions. Set the handle in such a

manner that the cutting head is slightly tilt-

ing forwards when in the working position.



Release the knurled nut (11) and

adjust the additional handle (12) in

the required position. Retighten

the knurled nut.