Florabest FBM 190 A1 - Manual (Page 65)

65
GB MT
- Drinks holder
- 2 cable clamps
- Assembly accessories for fixing the
bar (to the bar holder)
- Spark plug socket
- Operating instructions
- Briggs & Stratton operating instruc-
tions
Initial Operation
Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Observe the Briggs & Stratton in-
struction manual supplied.
Before starting the equipment, you must
- Install the handle bar
- Install the grass collection box / mulch
kit / side ejection channel as required
- Install the starter cord
- Fill with engine oil
- Fill with petrol
Installing the Handle Bar
Caution! When installing the
handle bar, ensure that the
Bowden cables ( 4) are not
squashed.
1. Unscrew the star knob (29) and
bar fixing screw and washer
from the bar holder (30).
2. Screw the lower handle bar (5)
onto the bar holder (30).
3. Unfold the upper handle bar (2)
(small image).
4. Push the quick-release lever
(21) towards the upper bar (2).
5. Fix the Bowden cables (4) to the
bar using the two cable clamps
(6).
Installing the Drinks Holder
Insert the drinks holder (24) into
the mounting from above. The
drinks holder clicks into place.
Installing the Starter Cord
1. Pull the safety catch (3) towards
the handle bar (2) and hold it.
2. Slowly pull the starter cord on
the starter handle (23) towards
the bar and hook the starter
cord into the starter cord guide
(22).
3. Release the safety catch (3).
Installing the Grass Collection
Box
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
The mulch kit and side ejection
channel must be removed before
using the grass collection box (see
, ).
Fixing the Grass Collection
Box onto the Equipment:
1. Lift the rear impact protection
(7).
2. Hook the grass collection box
(20) into the mounting provided
for this (31) on the rear of the