Florabest FRT 18 A1 - Manual (Page 56)

56
GB MT
disk are tight.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Replacing the cutting insert
1. Slide the cutting insert (13) in-
ward and push it out of the pin
(24) on the cutting disk (12).
2. Place the new cutting insert (13)
on the pin (24) and pull out the
insert until it snaps in.
Storage
• Store the trimmer in a dry place well
out of reach of children.
• Do not stand the trimmer on its pro-
tective cover. Suspend it by its upper
handle in such a manner that the
protective cover does not come into
contact with other objects. This is be-
cause the protective cover could be-
come deformed, thereby changing its
dimensions and its safety properties.
• In order to keep the battery well
charged, avoid exposing the appli-
ance to extreme heat or cold in stor-
age.
• Remove the battery before storing the
unit for longer periods of time.
Disposal and protection
of the environment
Remove the battery from the device and
take the device, battery, accessories and
packaging for environmentally friendly
recycling.
Machines do not belong with domes-
tic waste.
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.
• After every trimming session, remove
grass and soil from the protective
cover and the trimming assembly.
• To thoroughly clean the trimming as-
sembly, remove the cutting insert
( 13) (see “Replacing the cutting
insert”) and use a sharp knife to clean
the pin ( 24).
General maintenance
• Prior to every use, check the appli-
ance for obvious defects such as
loose, worn or damaged parts.
Check that the screws in the cutting