Florabest FRM 1800 A1 - Manual (Page 48)

48
MT GB
Spare parts
The following spares are available from
Grizzly Service-Center (see P. 65 for the
address). Please indicate the machine type
and the number of the spare part with your
order.
Spare blade ...............................13700300
If further spare parts should be necessary,
please find the part number on the exploded
drawing.
Technical
Specifications
Electric Lawnmower ......... FRM 1800 A1
Motor input power ......................... 1800 W
Mains voltage ......................230V~, 50 Hz
Idling speed .............................. 3250 min -1
Blade width ..................... Approx. 440 mm
Cut height ...............................20 – 70 mm
Protection class ................................... II
Protection type.................................. IP 24
Weight ...........................................18.3 kg
Lawn bag volume ................................50 l
Sound pressure specification
(L
pA
) ............74,8 dB(A); K
pA
= 2,26 dB(A)
Noise level specification
measured (L
WA
)
..................93,9 dB(A); K
wA
=2,26 dB(A)
guaranteed ............................96.0 dB(A)
Vibration on the handle
(a
n
) ...................... 2,07 m/s 2 ; K= 1,5 m/s²
≥100A
The equipment is intended only for
use in premises in which the current
bearing capacity of the network is
>=100 A per phase and which are
supplied by a distribution grid with a
nominal voltage of 400/230V.
To be on the safe side, check with
your local electric utility to verify that
the junction point of the mains has
enough continuous current carrying
capacity for the unit.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure as-
sessment.
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the op-
erating cycle are to be considered,
including, for example, times during
which the power tool is turned off
and times when the tool is turned on
but is running idle).
The noise and vibration values have been
determined in accordance with the stand-
ards and regulations specified in the decla-
ration of conformity.
Technical and visual modifications may be
made without notice in the course of further
development. All dimensions, informa-
tion and specifications in these operating
instructions are therefore not guaranteed.
As such, no assertion of legal claims can
be enforced on the basis of the operating
instructions.