Crivit MP-2058 - Manual (Page 16)

16 GB
Congratulations!
With your purchase you have decided on a high-
quality product. Get to know the product before you
start to use it. Carefully read the following instruc-
tions for use. Use the product only as described and
only for the given areas of application. Keep these
instructions safe.
When passing the product on to a third party, al-
ways make sure that the documentation is included.
Scope of delivery /
part names (fig. a)
1 x Mini bicycle pump (1)
1 x Top cap (2)
1 x Rubber ring (3)
1 x Bike mount (4)
1 x Bottom cap (5)
2 x Screws (6)
1 x Hose (7)
1 x Schrader valve (8)
1 x Dunlop valve (9)
1 x Sclaverand valve (10)
1 x Instructions for use
technical data
Dimensions: length approx. 190mm
Nominal pressure: approx. 120 PSI/8.3 bar
correct use
This article was developed for private use to pump
all standard bike tyres with Schrader, Dunlop, or
Sclaverand valves. The bike mount is only suitable
for bike frames that have holes for a mount (fig. B).
Not suitable for pumping up car tyres!
Safety notes
• This article is not suitable for use by children or by
adults with physical and/or mental limitations
because of the high operating forces and the
associated risks.
• risk of burns! The friction in the mini air pump
piston and mini air pump cylinder means that they
warm up after longer periods of use. Only hold
the article by the handle after use.
• Inspect the article in particular the bike mount and
the correct connection between the valve and the
mini air pump for damage or wear before each
use.
• Defective articles must not be used and must be
discarded as a defective article cannot be re-
paired.
• Only pump up the article to the maximum pressure
stated by the manufacturer. This is usually printed
on the sidewall of the bike tyre.