Crivit 1-LD3473 - Manual (Page 40)


- 77 -
Wearing the chest belt
Adjust the chest belt so that it fits
snugly directly below the chest
muscles. Moisten the contact areas
with water or ECG gel (ECG gel can
be purchased at a pharmacy). Ensure
that the contact areas constantly
remain in skin contact.
Position the chest belt as per the
following illustration.
Please ensure that the chest belt is
seated properly. When you have
exhaled completely the chest belt
should still have very slight tension
pressing it to your chest.
High voltage power lines, Trains or
moving vehicular traffic may interfere
with the heart rate measurement.
Please consider this when planning
your exercise route.
Using the bicycle holder
The included bicycle holder can
be used to attach the wrist watch
to the handlebar of a bicycle.
Press the bicycle holder onto the
top of the handlebar. Handlebars
with an especially large diameter
may require the use of additional
force to snap on the bicycle
holder. The heart rate monitor can
now be attached to the bicycle
holder in the same way that you
would attach it to your wrist.
contact area

- 78 -
The maximum range of 70cm between the wrist watch and the chest belt should
not be exceeded.
Important notes on the operation of the wrist watch
The watch has
3 different Modes of Operation.
Press MODE to select the mode of operation of the watch.
The order of the modes is as follows:
Time and basic settings
TIME ZEIT TEMPS HORA
stop watch
CHRONO ST-UHR CHRONO CRONO
heart rate
HRM PULS FC PULSO
Each mode of operation may have several subfeatures.
The subfeatures can always be accessed by pressing SEL.
Speed setting
When setting numerical values, press and hold SEL to use the speed setting
feature.
Light
Briefly press LIGHT to temporarily activate the light.