Kichler 337010 Dual Speed and Light Switch - Manual

337010
WARNING
To avoid fire, shock and serious personal injury, follow these instructions:
1. Carefully read and retain this Instruction Manual for future reference.
2. To avoid possible electrical shock, be sure the electricity is turned off at
the main panel by removing the fuse or opening the circuit breaker.
3. This control switch is designed for use with "Ceiling Fans" ONLY. DO
NOT use with any other type of electrical appliance.
4. All wiring must conform to national and local electrical codes. If you feel
you do not have enough electrical knowledge, have a licensed electrician
install the control.
5. The amperage for your fan should not exceed 1.25A. The total wattage
for the lights 300W.
INSTALLATION AND OPERATING
INSTRUCTIONS
1. Disconnect the power and remove the existing wall plate and switch. (Fig. 1)
2. Push BOTH slide switches all the way down to the OFF position. (Fig.2)
3. Make each of the wire connections illustrated in Figure 3. Secure each
with the wire nuts provided.
Black wire going to the fan (motor) to the Black wire from the Switch.
In the Ceiling Outlet Box, connect the White (neutral) wire coming from
the Fan to the White (neutral) wire from the Household Supply.
Connect the Blue (For Light) wire coming from the fan to the Blue (For
Light) wire from the Switch.
Connect the Black & White (AC IN L) from the switch to the Black wire
going to the Household Supply.
4. If your ceiling outlet box has a ground wire (green or bare copper) connect
it to the ground wire from the ceiling fan and/or the ceiling mounting
bracket.
Fig. 2
Fig. 1
Fig. 3
1
DUAL SLIDE WALL CONTROL
INSTALLATION INSTRUCTIONS
Wall plate
Switch
Outlet box
Light
switch
Speed
switch
Blue (for light)
light switch lead
Black/white (AC IN L)
to hot household
Black (to motor)
speed control lead Green ground ( ) lead
Fan
SUPPLY CIRCUIT
BLACK/
WHITE
BLACK
BLUE
BLACK BLUE
BLACK
Ground Conductor
Outlet Box
Green Ground Lead
Ground to Downrod
GREEN
WHITE
WHITE