Kichler 49455 User Manual

We’re here to help

Date Issued: 10/18/13

IS-49455-US

MOUNTING STRAP

PLANCHA PARA

MONTAR

CANOPY

ESCUDETE

SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.

THREADED BALL

BOLA ROSCADO

CAGE

JAULA

BALL STUD

ESPÁRRAGO DE CABEZA

ESFÉRICA

GLASS

VIDRIO

1) Lower metal ring down into cage. Set metal ring into bottom

of cage.

2) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your

home. Place the main power switch in the “OFF”

position.

b) Unscrew the fuse(s), or switch “OFF” the circuit breaker

switch(s), that control the power to the fixture or room

that you are working on.

c) Place the wall switch in the “OFF” position. If the fixture

to be replaced has a switch or pull chain, place those in

the “OFF” position.

3) Find the appropriate threaded holes on mounting strap.
Assemble mounting screws into threaded holes.
4) Attach mounting strap to outlet box. (Screws not provided).
Mounting strap can be adjusted to suit position of fixture.
5) Grounding instructions: (See Illus. A or B).
A) On fixtures where mounting strap is provided with a hole

and two raise dimples. Wrap ground wire from outlet

box around green ground screw, and thread into hole.

B) On fixtures where a cupped washer is provided. Attach

ground wire from outlet box under cupped washer and

green ground screw, and thread into mounting strap.

If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector.
(Not provided.) After following the above steps. Never connect
ground wire to black or white power supply wires.

6) Make wire connections (connectors not provided.) Reference
chart below for correct connections and wire accordingly.

7) Push fixture to wall, carefully passing mounting screws
through holes.
8) Secure fixture to wall using threaded balls.
9) Insert recommended bulb.
10) Lower glass down into cage.
11) Raise cage up to fixture. Fit top edge of cage inside roof of
fixture.
12) From the underside of the edge of the cage, thread ball
studs up through holes in edge of cage and into holes in
roof. Tighten ball studs to secure cage in place.

INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/
OR IN WET LOCATIONS.
13) Mounting surface should be clean, dry, flat and 1/4” larger

that the canopy on all sides. Any gaps between the mounting

surface and canopy exceeding 3/16” should be corrected

as required.

14) With silicone caulking compound, caulk completely around

where back of canopy meets the wall surface to prevent

water from seeping into outlet box.

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

(NOT PROVIDED)

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

Connect Black or

Red Supply Wire to:

Connect

White Supply Wire to:

Black

White

*Parallel cord (round & smooth)

*Parallel cord (square & ridged)

Clear, Brown, Gold or Black

without tracer

Clear, Brown, Gold or Black

with tracer

Insulated wire (other than green)

with copper conductor

Insulated wire (other than green)

with silver conductor

*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)

Neutral Wire