Kichler 350011 - Manual (Page 3)

2
4 Light Fixture
Fig. 2
Light fixture
assembly
Square connectors
Screws
Mounting plate
o=o
=o=o
=o=o
=o=o
=o=o
=o
Fig. 1
Light fixture
Nut
Lock washer
Center
plug
Switch
housing
3. INSTALLING THE LIGHT FIXTURE
NOTE: These instructions illustrate a
"Typical" ceiling fan and are not intended to
represent all situations. This light fixture
should fit almost any ceiling fan on the market
today. However, if you have any questions,
please consult a qualified technician at the
store where you purchased your light fixture.
1. Remove and discard the center plug from
the switch housing. Attach the light fixture to
the switch housing by feeding the light fixture
wires (black and white) through the hole in the
center of the switch housing, then screw the
light fixture stem onto the switch housing.
Thread the nut & lock washer onto the light
fixture stem inside the switch housing making
sure the light fixture is secure, preventing
movement after installation. (Fig. 1)
2. Locate the white and blue wires inside the
switch housing labeled FOR LIGHT.
3. Attach the wires from the light fixture to the
wires inside the switch housing by pushing the
polarized connections together.
- White wire to White wire
- Black wire to Blue wire
4. Raise and hold the light fixture assembly
close to the mounting plate of the ceiling fan.
Push the square wire connectors together.
(Fig. 2)
NOTE: The square connectors are color
coded. Match the color coded sides of each
plug and push. They will attach ONLY when
matched correctly.
5. Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 2)