Elmo Visual Presenter HV-5100XG - Manual (Page 31)

1
2
3
4
5
6
7
8
9
10
11
30
■ Powered Manual Focus
To focus on specific part of the material, such as 3-D
material.
Press the focus button [FOCUS NEAR] or [FOCUS
FAR] on the wireless remote control.
The powered manual focus function works up to a
height of approx. 10cm (3.9 in) above the stage
surface when the zoom button [TELE] is set to the
maximum.
Preset Operation
Operation status of this product can be stored / read out
in the memory (max. 8 states can be stored). Operation
states that can be stored are as shown below.
• Present zoom angle of view
• The iris state of Auto/Manual selection and its statue.
• White balance status
• ON/OFF of aperture
• Status of gamma
• Lighting status
• Status of color/B&W switch
• Status of mouse pointer ON/OFF, color and shape
• Status of image rotation
• ON/OFF of contrast mode
• Status of POSI/NEGA conversion
• Status of F.A.M. selection
1. How to store
Press the [PRESET.SET] button on the wireless
remote control and press the [MEMORY NO.]
button of the wireless remote control within "4 sec
or less", then the current status of this product is
saved in the pressed number memory.
2. How to read out operation status
Press the [PRSET.CALL] button on the wireless
remote control and press the [MEMORY NO.]
button of the wireless remote control within "4 sec
or less", then this product is set to the memorized
status correspond to the number.
PAUSE
LAMP POSI/NEGA COLOR/B&W
IRIS
AF
2x
SET
RGB1 RGB2
NORMAL OPEN CLOSE
PRESET CALL
TELE ZOOM
MAIN MONITOR
OUTPUT
WIDE NEAR FOCUS FAR
UPPER BASE
SET IMAGE CALL
PAUSE
LAMP POSI/NEGA COLOR/B&W
IRIS
AF
2x
SET
RGB1 RGB2
NORMAL OPEN CLOSE
PRESET CALL
TELE ZOOM
MAIN MONITOR
OUTPUT
WIDE NEAR FOCUS FAR
UPPER BASE
SET IMAGE CALL
The preset (stored) status
is maintained even when
the power is turned OFF.
Wireless remote control
Wireless remote control