beautypg.com

Maintenance and service – Empire Comfort Systems BVD36FP32 User Manual

Page 27

background image

Page 27

19400-3-0406

PLEASE NOTE

It is normal for appliances fabricated of steel to give off

some expansion and/or contraction noise during the start

up or cool down cycle. Similar noises are found with your

furnace heat exchanger or car engine.

It is not unusual for your gas fireplace to give off some odor the

first time it is burned. This is due to the curing of the paint and

any undetected oil from the manufacturing process.
Please ensure that your room is well ventilated - open all

windows.
It is recommended that you burn your fireplace for at least six

(6) hours the first time you use it. If optional fan kit has been

installed, place fan in the “OFF” position during this time.
IMPORTANT:
Turn off gas before servicing appliance. It is

recommended that a qualified service person perform these

check-ups at the beginning of each heating season.
• Clean Burner and Control Compartment

Keep the control compartment, logs, and burner areas surrounding

the logs clean by vacuuming or brushing at least twice a year.

Cleaning Procedure

1. Turn off pilot light at gas valve.

2. Vacuum burner compartment.

3. Ignite pilot (if applicable). (See Lighting Instructions)

4. Operate the pilot burner (if applicable). If it appears abnormal

call a service person.

• Check Vent System

The appliance and venting system should be inspected before

initial use and at least annually by a qualified service person.

Inspect the external vent cap on a regular basis to make sure

that no debris is interfering with the air flow.

Glass Cleaning (Optional Kits)

It will be necessary to clean the glass periodically. During start-up

condensation, which is normal, forms on the inside of the glass and

causes lint, dust and other airborne particles to cling to the glass

surface. Also initial paint curing may deposit a slight film on the

glass. It is therefore recommended that the glass be cleaned two

or three times with a non-abrasive household cleaner and warm

water (we recommend gas fireplace glass cleaner). After that the

glass should be cleaned two or three times during each heating

season depending on the circumstances present.
General Glass Information
Only glass approved for use by the manufacturer may be used for

replacement. The glass replacement should be done by a licensed

or qualified service person.
WARNING:

1. The use of substitute glass will void all product warranties.

2. Care must be taken to avoid breakage of glass.

3. Do not abuse the glass by striking or hitting the glass.

WARNING: Do not use abrasive cleaners on glass. Do not

attempt to clean glass when glass is hot.

MAINTENANCE AND SERVICE

This manual is related to the following products: