Emerson Radio ES30 - Manual (Page 40)

3 9
10.) Position the main unit over the two screw heads so that the heads of the
screws fit into bottom of each "Keyhole" on the back cabinet. When the two
screw heads are inside the keyholes, slide the main unit slightly downward
until each screw head is in the top of the keyhole.
If the main unit is still loose, you probably left too large a gap between the screw
head and the wall. Slide the unit slightly upward and take it off the mounting screws.
Tighten one or both screws slightly and remount the unit. It should fit snugly against
the wall and not move when you are loading or unloading CD.
Follow a similar procedure to mount each speaker.
Notes:
• It will be necessary to remove the main unit from the wall to connect the
speaker wires. If there is any excess speaker wire hanging between the
main unit and the speakers, remove the speaker from the wall and use a
twist-tie to secure the excess wire to the lower metal bracket on the back of
the speaker cabinet, then remount the speakers.
• You can also purchase plastic cord covers at most home improvement
centers. These covers can easily be cut to any desired length and attached
to the wall to conceal the speaker wires and AC power cord if necessary.
The covers can also be painted or wall papered to match the surrounding
wall surface.
Insert Screw Head
Into Keyhole.
Slide Unit Downward
To Lock Unit In Position.
ES30_072905.p65 29/7/2005, 16:41 39