Emerson Radio ES30 - Manual (Page 13)

1 2
Installing The Remote Control Batteries
The remote controller requires 2 “AAA” batteries (not included). Please use a well-
known brand of alkaline batteries for longest life and best performance.
Remove the remote control battery compartment cover by sliding the cover in the
direction of the arrow..
Insert 2 “AAA” alkaline batteries into the compartment. Be sure to observe the
polarity markings inside the battery compartment. If the batteries are inserted
incorrectly the remote control will not operate.
The remote control must be pointed at the remote sensor on the lower part of the
front panel. The effective operating range of the remote control is approximately
15 feet. The effective operating angle is approximately 15 degrees to the left or
right of ‘dead center’.
When the operation of the remote control becomes intermittent, or the operating
range of the remote is reduced, replace the batteries.
Battery Precautions
• Replacement of batteries must be done by an adult.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
• The supply terminals are not to be short-circuited.
• Non-rechargeable batteries are not to be recharged.
• Exhausted batteries are to be removed.
• Only batteries of the equivalent type are to be used.
• Batteries are to be inserted with the correct polarity.
• Dispose of batteries properly. Do not dispose of batteries in fire. The batteries
may explode or leak.
ES30_072905.p65 29/7/2005, 16:41 12