beautypg.com

Dmx addressing – Elation Professional Work Light User Manual

Page 30

background image


Platinum Spot LED™

©Elation Professional, Los Angeles Ca.

30

www.ElationLighting.com

9. DMX ADDRESSING

Setting the DMX address - After the fixture is turned “ON” it will immediately complete a

reset process that test all the fixture’s functions. When the reset process concludes the LCD

will display the fixture’s current DMX. If the fixture is not receiving a DMX signal, the display

will flash continuously. To set or adjust a DMX address, please follow the procedure below:

1. Toggle through the menu by pressing the Up and Down buttons until the display

reads “Address=XXX.” Tap the enter button to make changes to the address.

2. While the display is flashing use the “UP” and “DOWN” buttons to select a new

address. Once the new address has been selected, lock the new address into

the fixture’s memory by pressing the “ENTER” button.

The DMX address is non-volatile and will remain in the fixture’s memory even when the

power to the unit is switched off. Memory is backed-up and retain by an internal power

source that should last about five years


Remote DMX addressing (RDMX) / Address Via DMX
- This function allows the DMX

address to be changed remotely from a DMX console. This setting requires special settings

for both the controller and the fixture. RDMX is on by default. This function may be turned on

and off, and is “ON” be default. Follow the procedure listed below to access the RDMX

functions: Fixture Settings:

1. Access the main menu and use the UP or DOWN to get to the “Personality” menu,

then press ENTER

2. Once in the “Personalities” menu, tap the UP or Down to get to the “Status

Settings “ menu, press ENTER.

3. Once in the “Status Settings” tap the UP or Down to get to the “Address via DMX”

function and press ENTER.

4. “Address via DMX” is the menu function that activates the RDMX function.

5. Press the UP button to display “ON” to activate this function, or “OFF” to

deactivate this function.

6. Press ENTER to confirm.

7. Press MODE/ESC to return to the main menu.