Ericsson EDN312 - Manual (Page 9)

Cabling
1/1531-HSD 101 41 Uen A 2004-01-30 5
3.1.2 Wiring EDGE Connectors
It is recommended to follow the “Best practice” wiring procedure when
wiring the EDGE connectors.
The EDGE connector can be mounted by using a Tool Kit. The kit consists
of a wiring bracket-tool and an LSA+ inserter-tool. Figure 3 on page 5
shows how to mount the wiring bracket-tool on the rods in a subrack.
Figure 3 Mounting the Wiring Bracket-Tool
The EDGE connectors must be mounted as shown in Figure 4 on page 6.
The wiring bracket-tool ensures that the cables are long enough so that the
IP DSLAM can be dismounted by pulling it out. In case the wiring bracket-
tool is not used, it is important to ensure that the cables are long enough.