Ericsson EDN312 - Manual (Page 11)

Cabling
1/1531-HSD 101 41 Uen A 2004-01-30 7
Figure 5 Tie Up the New cable
Connect and cut the wires (one action using the KRONE LSA+ Insertion-
Tool S, see Figure 6 on page 7) by placing the Insertion tool above the slit
(place the cutting end towards the connector’s center), and firmly press
towards the connector. Repeat this step for all wires.
Figure 6 Cutting and Connection a Wire
It is recommended to label the EDGE connectors with the same number as
the LAN cable and tie up the Exchange and Line EDGE connectors
together according to Figure 7 on page 8.