Powerplus POWX0178LI HAMMER DRILL 14,4V LI-ION EN - Manual (Page 8)

POWX0178LI
EN
Copyright © 2010 VARO P a g e | 8 www.varo.com
Always wait until the machine has come to a complete stop before
placing it down.
Before any work on the machine (e. g., maintenance, tool change, etc.)
as well as during transport and storage, set the rotational direction
switch to the centre position.
Avoid unintentional switching on. Ensure the On/Off switch is in the off
position before inserting battery pack.
In case of damage and improper use of the battery, vapours may be
emitted. Provide for fresh air and seek medical help in case of
complaints.
When the battery is defective, liquid can escape and come into contact
with adjacent components. Check any parts concerned.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND
CHARGERS
Batteries
Protect the battery charger from rain and moisture.
Recharge only with the charger specified by the manufacturer.
Do not charge other batteries.
Keep the battery charger clean.
Check the battery charger, cable and plug each time before using. Do
not use the battery charger when defects are detected. Do not open the
battery charger yourself and have it repaired only by qualified personnel
using original spare parts.
Do not operate the battery charger on easily inflammable surfaces (e. g.
paper, textiles, etc.) or in combustible environments.
Under abusive conditions, liquid may be ejected from the battery; avoid
contact. If contact accidentally occurs, flush with water. If liquid contacts
eyes, additionally seek medical help.
Do not open the battery yourself.
Protect the battery against heat, e.g., including against continuous sun
irradiation and fire.
Do not short-circuit the battery.
In case of damage and improper use of the battery, vapours may be
emitted.