Powerplus POWX0178LI HAMMER DRILL 14,4V LI-ION EN User Manual

Page 13

POWX0178LI

P a g e

| 13

www.varo.com

For low temperatures, the power tool reaches the full hammer/impact

capacity only after a certain time.

10.4

Setting the Speed/Impact Rate

The speed/impact rate of the switched on power tool can be variably
adjusted, depending on how far the On/Off switch is pressed.
Light pressure on the On/Off switch results in low speed/impact rate.
Further pressure on the switch increases the speed/impact rate.

10.5

Battery Charge-control Indication

The battery charge-control indicator indicates the charge condition of the
battery for a few seconds when the On/Off switch is pressed through
halfway of fully.
LED

Capacity

All four LED

′

s are on

> 90%

Three LED

′

s are on

> 70%

Two LED

′

s are on

> 30%

One LED is on

≤

30%

Once only the one LED is lit, the screwdriver must be re-
charged.

10.6

Temperature Dependent Overload Protection

When using as intended for, the power tool can’t be subject to overload.
When the load is too high or the allowable battery temperature of 70 °C is
exceeded, the electronic control switches off the power tool until the
temperature is in the optimum temperature range again.
Additionally, the battery charge-control indicator flashes green at the same
time until the On/Off switch is released.

11 CLEANING AND MAINTENANCE

Attention !Before performing any work on the equipment,
pull the power plug.