Powerplus POWX0178LI HAMMER DRILL 14,4V LI-ION EN - Manual (Page 12)

POWX0178LI
EN
Copyright © 2010 VARO P a g e | 12 www.varo.com
Note: Change the operating mode only when the machine is switched off!
Otherwise, the machine can be damaged.
To change the operating mode, turn the selector switch for “drilling/hammer
drilling” to the requested position.
Position for hammer drilling in concrete or stone
Position for drilling without impact in wood, metal, ceramic
and plastic as well as for screwdriving
10.2 Reversing the Rotational Direction (see figure D)
Actuate the rotational direction switch (7) only when the
machine is at a standstill.
The rotational direction switch is used to reverse the rotational direction of
the machine. However, this is not possible with the On/Off switch actuated.
Right Rotation: For drilling and driving in screws, push the rotational
direction switch right to the stop.
The indicator for right rotation lights up when the On/Off switch
is actuated and the motor is running.
Left Rotation: For loosening and unscrewing screws and nuts, press the
rotational direction switch through to the left stop.
The indicator for left rotation lights up when the On/Off switch is
actuated and the motor is running.
10.3 Switching On and Off
To start the machine, press the On/Off switch (8) and keep it pressed.
To switch off the machine, release the On/Off switch.