Powerplus POWX0178LI HAMMER DRILL 14,4V LI-ION EN User Manual

Page 11

POWX0178LI

P a g e

| 11

www.varo.com

The SDS-Plus tool holder can also accommodate different drill-bit types
with hexagon shank.
Use only bit with SDS-Plus. Other bits can be used with a keyless chuck
with SDS-Plus.
The dust protection cap largely prevents the entry of drilling dust into the
tool holder during operation. When inserting the tool, take care that the
dust protection cap is not damaged.

A damaged dust protection cap should be changed
immediately. We recommend having this carried out by an
after-sales service.

9.2.1

Inserting SDS-Plus Drilling Tools (see figure B)

Clean and lightly grease the shank end of the tool.

Insert the tool in a twisting manner into the tool holder until it latches

itself.

Check the latching by pulling the tool.

9.2.2

Removing SDS-Plus Drilling Tools (see figure C)

Push back the locking sleeve 3 and remove the tool.

9.2.3

Dust/Chip Extraction

Dusts from materials such as lead-containing coatings, some wood types,
minerals and metal can be harmful to one’s health. Touching or breathing-
in the dusts can cause allergic reactions and/or lead to respiratory
infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered as carcinogenic,
especially in connection with wood-treatment additives (chromate, wood
preservative). Materials containing asbestos may only be worked by
specialists.

OPERATION

10.1

Setting the Operating Mode

With the selector switch for “drilling/hammer drilling”, the operating mode of
the machine is selected.