Powerplus POWX0178LI HAMMER DRILL 14,4V LI-ION EN User Manual

Page 10

POWX0178LI

P a g e

| 10

www.varo.com

TO CHARGE
! Charge battery pack only with the charger provided ! Using an other
charger can cause severe damage or even cause battery to explode

WARNING! Do not continue to press the On/Off switch after the machine
has been automatically switched off. The battery can be damaged. The
battery is equipped with a NTC temperature control which allows charging
only within a temperature range of between 0 °C and 45 °C. A long battery
service life is achieved in this manner.
When the battery charge-control indicator lights up

ONE LED

for approx. 5

seconds with the On/Off switch pressed through halfway or fully, then the
battery has less than 30% of its capacity and should be charged.
The charging procedure begins as soon as the mains plug of the battery
charger is plugged into a socket outlet and the charge connector is plugged
into the socket on the bottom of the handle.
The battery charge-control indicator, indicates the charging progress.
During the charging process, the indicator LED lights from one to four.
When the battery charge-control indicator all four LED’s are green, the
battery is fully charged.
During the charging procedure, the handle of the machine warms up. This
is normal. Disconnect the battery charger from the mains supply when not
using it for longer periods.
The power tool cannot be used during the charge procedure; it is not
defective when inoperative during the charging procedure.

Protect the battery charger against moisture!

Observe the notes for disposal.

9.2

Charging the Tool

The SDS-Plus tool holder allows for simple and convenient
changing of drilling tools without the use of additional tools.

Due to their working principle, SDS-Plus drilling tools move freely. This
results in radial run-out at no-load. However, this has no effect on the
accuracy of the drill hole, as the drill bit centres itself during drilling.