Powerplus POW8561 TABLE SAW 1800W 250MM EN - Manual (Page 9)

POW8561 EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
8.3 Workpiece stops
8.3.1 Mitre angle stop
The stop can be adjusted by a maximum of 120mm for mitre cutting.
Risk of injury! Do not push the stop (A) too far in the direction of the saw
blade. The gap between the stop (A) and the saw blade should be
approximately 2 cm.
8.3.2 Mitre cuts (Fig. 6)
 Push the mitre angle stop (9) into the required bar of the table surface.
 Loosen adjusting screw (A), set the required angle and then tighten the adjusting screw
again.
 If necessary, push the stop plate (c backwards or forwards. For this, loosen both adjusting
screws (B), push stop plate (C) and then retighten adjusting screws (B).
8.3.3 Setting the stop rail of the parallel stop
The stop rail can be removed and repositioned after both wing nuts have been loosened:
High stop edge:
 To saw tall workpieces.
Low stop edge:
 To saw flat workpieces.
 If the saw blade is angled.
8.3.4 Parallel stop
 Loosen the locking lever (21) by turning the knob.
 Set the parallel stop to the required cutting width by pushing on the scale.
 Press down the locking lever (21).
8.4 Setting the cutting height (Fig. 7)
Risk of injury! Parts of the body or objects located in the adjustment area
may be caught by the operating saw blade! Only adjust the cutting height
when the saw blade is at a standstill!
 Adjust the cutting depth by turning the hand crank (A).
 Turning the hand crank clockwise reduces the cutting depth-Turning the hand crank anti-
clockwise Increases the cutting depth.
Note: To balance out play in the cutting height setting, always raise the saw
blade from below to the required position.
The cutting depth is optimally set when the saw blade is one blade tooth
higher than the wofkpiece.