Powerplus POW8561 TABLE SAW 1800W 250MM EN - Manual (Page 7)

POW8561 EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
7.2 Fitting the parallel fence (Fig. 4)
Insert the parallel fence (5) into the rail of the measuring scale. Check the setting at the
window. Turn the knob to lock the parallel fence (5) into place. In order to obtain a perfectly
parallel cut, you should check the gap between the fence and the saw blade at two positions
using a meter rule.
7.3 Mounting mitre angle stop (Fig. 5)
The mitre angle stop (9) consists of two parts - the stop plate (A) and the angle adjustment (B)
that must be assembled together.
 Insert the stop plate (A) into the gaps of the angle adjustment (B) with both adjusting
screws (C), push into the required position and tighten the adjusting screws.
Push the gliding bar (D) of the mitre angle stop into the required bar of the table surface.
Note: Whether you insert the stop plate (A) with the long side upwards or
downwards is determined by the height of the workpiece.
Right-handed operators prefer to push the mitre angle stop into the left bar
of the table surface.
7.4 Mounting the saw blade protector
Risk of injury! The saw blade must be lowered as far as possible in order to
avoid injury.
 Lower the saw blade with the hand crank for height
adjustment (4) so that the drill hole (A) in the
cleaving wedge (7) is still accessible.
 Loosen wing nuts on the saw blade protector (6)
and remove together with the bolt screw and
washer.
 Position the saw blade protector (6) with the
groove on the cleaving wedge and align the hole of
the saw blade protector with the hole of the
cleaving wedge.
 Fit the bolt screw through the hole and fix with
washer and wing nut.