Powerplus POW8561 TABLE SAW 1800W 250MM EN - Manual (Page 8)

POW8561 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
7.5 Mounting the extraction
 Push one end of the extraction hose (11)
onto the struts of the saw blade protector (6)
and the other end onto one of the struts of
the connection (13).
 Fix a suitable vacuum unit to the other strut
of the connection (13).
8 OPERATION
Risk of injury! In the event of a functional fault, immediately press the red
button 0 on the On / Off switch and unplug.
8.1 Check before starting the device!
Risk of injury! The device may only be put into operation if there are no
defects. If a part is defective danger it must be replaced before the device is
used again.
Check to make sure the device is in safe operating condition:
 Check to make sure there are no visible defects.
 Check to make sure all device components are correctly mounted.
 Check to make sure the safety equipment is functioning properly.
 Check to make sure that the saw blade runs freely.
 Check whether the adjusting screw for setting the angle of tilt is tightened.
8.2 Operating elements
8.2.1 On/off switch
 Switching on: Pressing the green button I on the On / Off switch (1) switches on the saw.
Before starting to saw, wait until the blade has reached maximum speed.
 Switching off: Pressing the red button 0 on the On / Off switch (1) switches off the saw.
8.2.2 Overload Protection (15)
The machine is fitted with an overload protection (15). Allow the machine to cool down for at
least 30 minutes before switching it on again. For this first press the black button next to the
switch, then press the green button (1) to restart the machine.
8.2.3 Setting mechanism for the tilt angle
The saw blade can be set to any angle between 0° and 45°.
8.2.4 Hand crank for setting the cutting height
The cutting height of the saw blade must be adjusted to the height of the workpiece. The saw
blade must always be lowered down onto the workpiece
Note: In order to make use of the full range of 45° settings, the cutting
height must be reduced accordingly.
6
13