Powerplus POW8561 TABLE SAW 1800W 250MM EN - Manual (Page 6)

POW8561 EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
5.5 Service
 Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 SAFETY EQUIPMENT
6.1 Cleaving wedge (Fig. 1)
The cleaving wedge (7) prevents a workpiece being caught by the ascending teeth and being
thrown against the operator. The cleaving wedge must remain in place during operation.
6.2 Saw blade protector
The saw blade protector (6) protects the user from accidentally touching the saw blade and
from flying splinters. The saw blade protector must always remain in place during operation.
6.3 Push stick (Fig. 2)
The push stick (16) serves as an extension of the hand and protects the user from accidentally
touching the saw blade. The push stick must always be used when the gap between the stop
and the saw blade is less than 120 mm.
7 UNPACKING AND ASSEMBLY
Unpack the unit and make sure all of the pieces are there.
Note: If any of the parts is missing or damaged contact the retailer.
7.1 Assembly
Mount base frame (12) and table enlargements and extensions
The base frame (12) consists of four table legs with cross braces that must be mounted.
Required tools:
2 combination wrenches
Allen wrench
 Connect the four table legs (1) with the four
cross braces (2). For this, fix each cross brace
from the inside with two screws (3) (incl.
washers) and counternuts (4) to each table leg.
The brackets (17) are fitted through the screw holes in the housing. (Fig. 3)
Note: Only place the device on a level, skid-proof surface. The device must
not wobble.
1
3
4
2