Powerplus POWLI423 EXT ENDABLE LED POCKET- / FLASHLIGHT 1W 3-IN-4 EN - Manual (Page 2)

POWLI423 EN
Copyright © 2014 VARO P a g e | 2 www.varo.com
4 WARNINGS
 Do not use if any parts are broken, bent, cracked or damaged. Any work light that
appears damaged in any way or operates abnormally must be removed from service
immediately. Inspect before each use.
 This work light is not to be used by children. Keep out of reach of children.
 Do not leave work light on and unattended.
 Do not expose to fire or high temperatures; the battery may explode.
 Do not charge or use near open flames or glowing embers.
 Do not shine directly into eyes.
 Never block lens and reflector during operation.
 Do not store the work light for an extended period of time. Charge the battery every
three months during storage.

Do not charge the battery for an extended period of time. Overcharging will greatly
shorten battery life.
 You must give the work light battery a top-up charge at the time of purchase.
 Avoid charging at temperatures below 4
℃.
 The DC charging plug may very warm when in use. Unplug from receptacle with
caution.
5 OPERATION
5.1 Magnetic base
The work light features a magnetic base on the bottom, allowing the light to be
magnetically attached to a vehicle or other metal objects.
NOTE Do not place the light on or near computer equipment,
computer disks or other types of magnetic storage equipment as
strong magnetic fields can erase or corrupt data.
5.2 Different modes
5.2.1 Floodlight mode
You can extend both sides of the torch. You can choose to use 15 LED or 30 LED.
Simply hold the torch and pull out the bottom and/or head. LED’s will illuminate
automatically. When you push in the sides, LED’s will automatically turn off.
5.2.2 Spotlight mode
To activate the top 1W light simply push the on/off switch situated on the pivoting head.
You can pivot the head by pressing the release knob and put the head at the desired
degree.
5.2.3 Emergency light
Emergecy light can be activated by pressing the on/off switch for the spotlight a second
time. Three red LED’s will start blinking. To switch of simply push the on/off switch one
more time.