Powerplus POW64115 CHAINSAW 37.2CC 406MM EN - Manual (Page 7)

POW64115 EN
Copyright © 2011 VARO P a g e | 7 www.varo.com
The push (pinch kickback) and pull reactions a
= pull
B = solid objects
C = push
7 ASSEMBLY
Note : described actions below may vary slightly depending on model you
purchased.
7.1 Tools for assembly
You will need these tools to assemble your chain saw:
 Combination wrench-
screwdriver (contained in your user’s kit).
 Heavy duty work gloves (user supplied).
7.2 Assembly requirements
Warning: do not start saw engine until unit is properly prepared.
Your new chain saw will require adjustment of chain, filling the fuel tank with correct fuel
mixture and filling the oil tank with lubricating oil before the unit is ready for operation.
Read the entire user manual before attempting to operate your unit. Pay particular attention to
all safety precautions.
Your user manual is both a reference guide and handbook provided to furnish you with
general information to assemble, operate and maintain your saw.
7.3 Guide bar / saw chain / clutch cover installation
Warning: always wear protective gloves when handling chain.
7.3.1 To install the guide bar
fig 3a
To ensure the bar and chain receive oil, only use
the original style bar with the oil passage hole (A)
as illustrated above. (fig. 3a)