Epson 214D-1 - Manual (Page 43)

Configuration 35
HP289
5.4 Checking the Input Signal
Step Display Description Text
Ref
1 TEST Check Input Signals
END Exit to normal operation
CAL Setup Program Parameters 5.1
BATCH Set Batch Parameters 5.2
OPTION Options (if installed) 5.3
The following steps are displayed when TEST is selected.
2 Sr x.xx Software revision number.
3 Freq Displayed for 1 second followed by the actual
frequency.
xxxx.x Frequency in Hz.
If the RS232/422/485 option is installed, the display will then show:
4 CLOC Clock.
xx:xx:xx Time in Hours:Mins:Sec.