Casio DT-X30 User Manual

Page 48

E-46

USB Client Port

This port is used to transmit system data and fi le data (download,
upload) by connecting the Ethernet Cradle to a PC using a USB
cable (DT-380USB). The dedicated driver must be installed in
the PC before connecting the Ethernet Cradle to the PC.

USB Host Port

This port is used to connect a corresponding USB peripheral
device.

LAN Connection
Status LED

This LED shows the status of the LAN connection.
Off: LAN cable not connected correctly.
Lit orange: LAN cable connected correctly.

LAN
Communication
Status LED

This LED shows the LAN operation status.
Off: No communication.
Blinking: Communication in progress.

LAN Port

This port is used for connecting the cradle to a PC or hub via a
LAN cable so that system data and fi le data can be transmitted
(uploaded or downloaded).
The special driver software must be installed in the DT-X30.

Selector Switch

This switch is used to switch between a USB connection and a
LAN connection.
LAN: LAN
A: USB host
B: USB client

AC Adaptor Jack

Connect the AC adaptor (sold separately) here.

Terminal Detect
Switch

This switch detects when the DT-X30 is seated correctly on the
Ethernet Cradle.

Power Contacts

Power is supplied to the DT-X30 via these contacts.

Power LED

This LED indicates the power status and the mounting status of
the DT-X30.
Off: DT-X30 is not installed.
Green: Power on, DT-X30 mounted correctly.

Important !

Never short out the contacts of the Ethernet Cradle. This can damage the
Ethernet Cradle.
Allowing the power contacts become wet can cause an electric shock or fi re. In
addition, if the contacts become soiled, contact may be impaired resulting in
poor charging. For reasons of safety and maintaining charging battery pack(s)
in optimum condition, clean the power contacts by wiping with a dry cloth or
cotton swab after disconnecting the AC adaptor.