Casio EX-MR1 - Manual (Page 19)

19
Quick Start Basics
.
To charge using a USB connection to a computer
USB connection lets you
charge the battery while it is
loaded in the camera.
While the camera is turned off,
connect in the sequence
shown below (
1 , 2 ). If the
camera is on, press [p]
(Power) to turn it off before
connecting it to your computer.
Charging time: Approximately
150 minutes
IMPORTANT!
• The first time you connect the camera to your computer with the USB cable, an
error message may appear on your computer. If this happens, disconnect and then
reconnect the USB cable.
• Depending on the setup of your computer, you may not be able to charge the
camera’s battery over a USB connection. If this happens, use of the USB-AC
adaptor that comes with the camera is recommended.
• Charging is not performed while the connected computer is in the hibernate mode.
USB
2
1
Micro USB cable
(included with camera)
u
mark of the small (micro USB) connector facing
the mirror side.
[USB] port
USB port
Computer
(power turned on)